Comfort Control AT0050

Autoterm - Comfort Controller (NEW OUT 2021) - AT0050 The long awaited Autoterm Comfort Controller has finally arrived. Works for the 2D, 4D and Flow 12v only. What will Comfort Control bring to the game? Intuitive user interface, LED status display, Thermostat function, Additional heating options, Quick access button for heating, Vehicle battery safety function, Heater maintenance reminder, Precise integrated digital temperature sensor. Temperature sensor Custom calibrated digital sensor with +/- 1.5 degree offset. Timers Max - 3 timers, Heating mode can be chosen for each timer, All 3 timers can be active simultaneously, Set timer is active continuously till disabled. Available cycles ED - Everyday, EW - Every workday, Custom days, Status display. Display LED red - heating, LED blue - ventilation, LED green - shutting down. Display dimensions (mm) 37 x 20 Control panel dimensions (mm) 82 x 37 x 19Heating modes for liquid heaters PRE-HEATING MODE: Heater will operate till the certain coolant temperature is reached then shuts off the combustion process. After the temperature of the coolant drops heating will start again. ECO MODE: (only for FLOW 14D) Pre-heating mode with reduced power and fuel consumption. Temperature of the coolant is reached slower than in Pre-heating mode. THERMOSTAT MODE: (only for Flow 5) Heater will operate till the specified interior temperature is reached then shuts off the combustion process. After the temperature drops by specified degrees heating will start again. Temperature is read by control panel. *for setting up Thermostat mode see instructions for AIR heaters. Heating modes for air heaters TEMPERATURE MODE: Heater will maintain set temperature by reducing the heating power, without shutting off the combustion process. POWER MODE: Heater will operate constantly at set power level. HEAT + VENTILATION: Heater will operate till the temperature is reached 1°C above the set temperature, shut off the combustion process and start to ventilate till the temperature drops 5°C below the set temperature. When temperature drops, heating starts again. THERMOSTAT MODE: Heater will operate till the specified temperature is reached then shuts off the combustion process and ventilation. After the temperature drops by specified degrees heating will start again.